LEVEL 1 and LEVEL 2 - use these knobs to adjust the input signal level of inputs 1 and 2.
The levels should be adjusted so that the CLIP LED does not come on duning loud passages.
The knobs adjust the left and right inputs equally.
-24 dB, 0 dB, CLIP LEDs - these LEDs show the input signal level of inputs 1 and 2.
Li the CLIP LED comes on regularly, the LEVEL knobs should be adjusted to reduce the input signal levels, otherwise there may be audio distortion.
LINE 1 and LINE 2 - use these knobs to adjust the signal level of charnels 1 and 2 playing in the zone. In normal operation, tur one knob to minimum, and adjust the other one to play the desired input in that zone. The level should be adjusted so that the zone's CLIP LED does not come on during loud passages.
MONO Switch -press this switch to combine the left and right channels to play in mono in the zone.
E 24dB, -6 dB, 0dB, + 6dB, CLP LEDs -
these LEDs show the output signal level of the zone. Adjust the LINE controlsso the CLIP LED does not come on.
@ POWER SWITCH -use this to turn the unit on and of. Only turn it on after all connections have been made.
REAR PANEL
AC POWER INPUT - this jack allows the connection of the supplied AC porer cord.
The other end of the cord connects to an
AC mains supply. The universal power supply in the unit can accept voltages from 100 VAC to 240 VAC, 50/60 Hz
FRONT PANEL
XLR Outputs - these left and right balanced outputs connect to the inputs of a power amplifier to power speakers in the zone.
Alternatively, powered speakers can be used.
Each zone can play either input l or input 2, and each zone has a pair of XLR male coutputs.
XLR Inputs - these left and night balanced inputs connect to the line-level balanced outputs of your source equipment, preamplifier, or mixer. Each input can play in any zone.
